Mazda Sedan Mazda3 Clicking noise when changing direction
What this problem usually means
2004, 2005 and 2007 Mazda3s can develop a stick-slip condition between the CV axle shaft and the wheel hub - alternating adhesion and sliding that produces clicking noises when changing gear direction, such as shifting between drive and reverse. The fix is installing a washer between the two parts.
Likely causes
- stick-slip between the cv axle shaft and wheel hub
How to fix it — step by step
- Listen for a single click when shifting between drive and reverse or when first pulling away
- Note whether the click comes from a front wheel area
- Have a shop confirm the axle-to-hub stick-slip rather than a worn CV joint
- Install the specified washer between the CV axle shaft and the wheel hub → Shop the cv axle at Amazon → Shop the washer at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the washer.
Also tied to this fault: cv axle - Shop at Amazon
Parts that commonly fix it
- washer - Shop at Amazon
- cv axle - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.