LG Window Air Conditioner FL Error Code
What the FL code means
On LG room/window air conditioners, FL indicates the drain pan in the unit is full. The same condition is displayed as P2 on other models. Normally the slinger fan throws pan water onto the condenser coil, so a full pan usually means very humid conditions or a drainage problem.
Likely causes
- Very high indoor humidity filling the pan faster than the slinger fan can clear it
- Unit not tilted slightly toward the outside, so water pools instead of draining
- Drain path blocked
How to fix it — step by step
- Remove the drain port cap and tilt the air conditioner slightly toward the back/outside so the water runs out
- If the room is very humid, set the fan speed to Low and keep doors and windows closed to slow moisture buildup
- Use Cool mode rather than Dry mode to reduce the amount of water collected
- If FL returns immediately after draining and a power reset, the unit needs repair service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the FL code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.