LG Window Air Conditioner E1 Error Code
What the E1 code means
Auto-stop protection error on LG room/window air conditioners: E1 is the alternate display form of CH02, indicating a short or open circuit in the indoor pipe (evaporator coil) sensor.
Likely causes
- Indoor pipe sensor failed (open or short circuit)
- Pipe sensor displaced from the coil or its wiring damaged
- Main control board sensor circuit fault
How to fix it — step by step
- Unplug the unit and wait about 2 minutes, then plug it back in
- If E1 reappears, the unit requires repair service to test and replace the indoor pipe sensor → Shop the indoor pipe sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the indoor pipe sensor.
Shop the indoor pipe sensor at RepairClinic or Amazon
Also tied to this fault: evaporator thermistor - Shop at RepairClinic or Amazon
Parts that commonly fix the E1 code
- indoor pipe sensor - Shop at RepairClinic or Amazon
- evaporator thermistor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.