Kenmore Washer 110 Series (Whirlpool-Built) Oasis Top-Load Sd Error Code
What the Sd code means
Excessive suds on Kenmore 110-series (Whirlpool-built) Oasis top-load washers. The control detects too much foam and runs a suds reduction routine; Sears PartsDirect lists this as Sd or F71 on this platform.
Likely causes
- Too much detergent used
- Regular or hand-washing detergent used instead of HE detergent
- Detergent buildup in the tub
How to fix it — step by step
- Use only High Efficiency (HE) detergent in this washer
- Measure detergent and use less on the next load
- Let the suds reduction routine finish and the foam clear
- Run a rinse cycle with no detergent if suds remain
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the Sd code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 110 Series (Whirlpool-Built) Oasis Top-Load error codes
See all Kenmore 110 Series (Whirlpool-Built) Oasis Top-Load codes & guides →