Kenmore Washer 110 Series (Whirlpool-Built) Oasis Top-Load oL Error Code
What the oL code means
Overload on Kenmore 110-series (Whirlpool-built) Oasis top-load washers: the washer tried to fill and start, found the load too heavy, and drains the water and detergent added. Also shown as oL or F70 on this platform.
Likely causes
- Basket packed too full or too tightly
- Load too heavy for the selected cycle
How to fix it — step by step
- Remove several items from the basket
- Loosen the remaining load so items move freely
- Add detergent for the smaller load if needed
- Close the lid and press START to restart
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the oL code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 110 Series (Whirlpool-Built) Oasis Top-Load error codes
See all Kenmore 110 Series (Whirlpool-Built) Oasis Top-Load codes & guides →