Jeep SUV Renegade Heater hose coolant leak
What this problem usually means
On first-generation (2015-present) Renegades a heater hose can rub on a vacuum line that runs in front of it, and over time the rubbing wears through the hose so it leaks coolant on that side of the engine. After replacing the hose, 1A Auto advises applying cut-proof padded tape over it to prevent the vacuum line rubbing through again.
Likely causes
- heater hose rubbing on a vacuum line until it wears through
- coolant leaking from the chafed section of heater hose
How to fix it — step by step
- Do not drive if the temperature gauge climbs, and let the engine cool fully before touching hoses
- Check the coolant level and look for a leak on the side of the engine where the heater hose runs → Shop the heater hose at Amazon → Shop the coolant at Amazon
- Inspect the heater hose where the vacuum line crosses it for chafing or wetness
- Replace the worn heater hose and apply cut-proof padded tape where the vacuum line contacts it
- Refill and bleed the cooling system and confirm the leak is gone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the heater hose.
Shop the heater hose at Amazon
Also tied to this fault: coolant - Shop at Amazon
Parts that commonly fix it
- heater hose - Shop at Amazon
- coolant - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.