Jeep SUV Renegade Front CV shaft clunk
What this problem usually means
Worn front CV shafts are a top-five problem on the first-generation (2015-present) Renegade according to 1A Auto, showing up as a clunk-type noise on acceleration or deceleration. The shafts drive the front wheels from the engine through the transmission, and the fix is to replace the shaft on the side making the noise, though replacing both does no harm.
Likely causes
- worn front cv shaft joints
- play in the cv shaft producing a clunk when load changes
How to fix it — step by step
- Note whether the clunk happens on acceleration, deceleration or both, and which side it comes from
- Inspect the CV shaft boots for tears and grease loss and check the shafts for play
- Confirm the noise is not from engine or transmission mounts before replacing parts
- Replace the CV shaft on the noisy side, or both shafts if both show wear
- Road-test through acceleration and deceleration cycles and confirm the clunk is gone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the front cv shafts.
Parts that commonly fix it
- front cv shafts - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.