Ecovacs Robot vacuum Deebot X1 DEEBOT does not respond to the Station instruction

What this problem usually means

The robot ignores commands from the OMNI Station.

Likely causes

  1. DEEBOT is too far away from the Station
  2. DEEBOT and the Station are not paired
  3. Communication interruption between the Station and DEEBOT (long distance or many partition walls)

How to fix it — step by step

  1. If it is beyond the available distance, use the ECOVACS HOME App to operate DEEBOT
  2. Unplug the Station, wait 10 seconds and plug it in again; power the robot off and back on; manually push the robot up to the Station so the charging pins connect — DEEBOT will start charging and voice-prompt that pairing was successful

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Ecovacs Robot vacuum Deebot X1 problems

See all Ecovacs Deebot X1 codes & guides →