Carrier Air Conditioner 71 Error Code
What the 71 code means
Low-stage thermal cutout, read as short/long flashes of the amber LED on the outdoor unit control board of a Carrier Infinity 24ANA two-stage air conditioner. Compressor operation was detected and then disappeared while a low-stage demand existed.
Likely causes
- Internal compressor overload trip
- Start relay and capacitor held in circuit too long (if installed)
- High discharge pressure or overheating compressor
How to fix it — step by step
- Turn the system off and allow the compressor to cool → Shop the compressor at RepairClinic
- Check that the outdoor coil is clean and the outdoor fan runs
- Have a technician check refrigerant pressures, the start relay/capacitor and compressor operation if the code repeats → Shop the run/start capacitor at RepairClinic → Shop the start relay at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Compressor.
Shop the Compressor at RepairClinic or Amazon
Also tied to this fault: Start relay - Shop at RepairClinic or Amazon; Run/start capacitor - Shop at RepairClinic or Amazon
Parts that commonly fix the 71 code
- Compressor - Shop at RepairClinic or Amazon
- Start relay - Shop at RepairClinic or Amazon
- Run/start capacitor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Carrier manual is on Carrier's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.