Audi SUV Q7 Turbocharger wastegate rattle

What this problem usually means

On the second-generation Q7's turbocharged 3.0T (EA839, 2016-2019), the electronic wastegate actuator can strip its internal gear teeth or suffer position sensor failure, causing boost control errors. Symptoms are a rattling noise from the engine bay at idle or low rpm like a loose heat shield, a check engine light with underboost (P0299) or overboost (P0234) codes, and limp mode. The turbocharger itself is usually fine, but Audi does not sell the actuator separately, so the fix is a whole turbocharger assembly.

Likely causes

  1. Stripped internal gears in the electronic wastegate actuator → Shop the wastegate actuator at Amazon
  2. Failed wastegate position sensor

How to fix it — step by step

  1. Listen for a rattle at idle and low rpm and note any loss of boost or limp mode
  2. Scan for P0299 or P0234 boost control codes
  3. Rule out a genuinely loose heat shield before condemning the actuator
  4. Have a specialist confirm actuator operation with diagnostic equipment
  5. Plan on turbocharger assembly replacement, since the actuator is not supplied separately → Shop the turbocharger at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Audi SUV Q7 problems

See all Audi Q7 codes & guides →