Whirlpool Washer Top-Load HE LF Error Code
What the LF code means
Long fill: the washer is taking too long to fill with water. This is the top-load display for the same fault as F8 E1.
Likely causes
- Faucets not turned on or not fully open
- Kinked or clogged inlet hoses/screens
- Drain hose installed too deep causing siphoning
- Low water pressure
How to fix it — step by step
- Open both hot and cold faucets completely
- Check inlet hoses for kinks and clean the inlet screens
- Check the drain hose is not pushed too far into the standpipe
- Press Pause/Cancel to clear and restart the cycle
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix the LF code
- water inlet valve - Shop at RepairClinic or Amazon
Before you buy: check the water inlet valve first
Test: Unplug the washer and measure each fill valve solenoid's coil resistance at the valve or at the ACU connector pins listed in the tech sheet.
A good one reads: 1100–1350 Ω per coil (Whirlpool tech sheet W11417646, Test #6). Older Duet solenoids spec 800 Ω — use the range on your model's tech sheet; open or far out of range means replace the valve assembly.
Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.