Whirlpool Washer Top-Load HE drn Error Code

What the drn code means

The washer is not draining properly, often an installation problem with the drain hose.

Likely causes

  1. Drain hose kinked, clogged or installed incorrectly
  2. Standpipe too low/high or hose sealed into the drain
  3. Clogged drain pump filter

How to fix it — step by step

  1. Check the drain hose for kinks and clogs
  2. Make sure the hose is not pushed too far into or taped into the standpipe
  3. Clean the drain pump filter if your model has one → Shop the drain pump at RepairClinic
  4. Restart a Drain & Spin cycle

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the drn code

Before you buy: check the drain pump first

Test: Unplug the washer, disconnect the wire connector at the pump, set the meter to the R×1 scale, and measure across the pump terminals.

A good one reads: Approximately 12.3 Ω (Whirlpool CHW9050 service manual). The value is generation-specific: Duet-era tech sheets spec 15 Ω and current Whirlpool tech sheet W11417646 specs 18.5–21.5 Ω, so confirm against your model's tech sheet.

Test values from manualslib.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related Whirlpool Washer Top-Load HE error codes

See all Whirlpool Top-Load HE codes & guides →