Whirlpool Washer Front-Load Int Error Code
What the Int code means
The cycle was paused or canceled; the washer may take 20 to 30 minutes to stop spinning and drain while this is shown.
Likely causes
- Cycle paused or canceled by the user
- Power interruption during the cycle
How to fix it — step by step
- Wait for the washer to stop spinning and finish draining
- Press Pause or Cancel twice and Power once to remove the code
- If it remains, unplug the washer for 5 minutes and restore power
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the Int code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.