Whirlpool Front-Load Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 9 codes covered.
Shop Whirlpool Front-Load parts at RepairClinic or Amazon
- dET — Detergent cartridge not detected in the dispenser (select models with a bulk detergent cartridge).
- F34 — Items were detected in the washer during the Clean Washer cycle, the same fault shown as rL on some models.
- F5 E2 — The door (front-load) or lid (top-load) is not locking properly, so the cycle will not start.
- F7 E1 — Motor speed sensing error: the motor cannot achieve or report the correct speed for the selected cycle; on belt-drive top-load models this…
- F8 E2 — Dispenser system problem: the detergent dispenser did not move or dispense correctly (select models).
- F9 E1 — Long drain: drain time is longer than expected, typically over 8 minutes.
- Int — The cycle was paused or canceled; the washer may take 20 to 30 minutes to stop spinning and drain while this is shown.
- LOC — Control Lock has been activated, so the controls are locked. Also shown as LC on some models.
- rL — Items were detected in the washer during the Clean Washer cycle. Also shown as F34 on some models.