Whirlpool Washer Front-Load F7 E1 Error Code
What the F7 E1 code means
Motor speed sensing error: the motor cannot achieve or report the correct speed for the selected cycle; on belt-drive top-load models this is a basket speed sensor fault.
Likely causes
- Shipping bolts not removed (front-load, new install)
- Washer overloaded
- Basket does not rotate freely / drive fault
- Failed shifter/speed sensor assembly → Shop the shifter assembly at RepairClinic
How to fix it — step by step
- Check all shipping bolts have been removed
- Remove some items if the load is large and redistribute it
- Check the basket spins freely by hand with the washer off
- Press Pause/Cancel twice and Power once to clear, then retry
- Unplug for 5 minutes if the code does not clear
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the shifter assembly.
Shop the shifter assembly at RepairClinic or Amazon
Also tied to this fault: drive motor - Shop at RepairClinic or Amazon
Parts that commonly fix the F7 E1 code
- shifter assembly - Shop at RepairClinic or Amazon
- drive motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.