Whirlpool Washer Front-Load F34 Error Code
What the F34 code means
Items were detected in the washer during the Clean Washer cycle, the same fault shown as rL on some models.
Likely causes
- Clothes or items left in the drum during Clean Washer cycle
- Items forgotten in the drum from a previous load
How to fix it — step by step
- Remove all items from the drum
- Restart the Clean Washer cycle with an empty drum
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the F34 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.