Volvo Sedan S60 ABS Control Module Failure

What this problem usually means

On 2001-2005 S60s the ABS control module frequently fails from internal solder joint failures: the ABS and check-engine lights come on, traction control is disabled, and the module needs repair or replacement. Buying guides rate the 2001-2005 cars 'avoid' largely on this module plus early transmission valve body failures, while 2006-2009 cars are substantially sorted.

Likely causes

  1. Internal solder joint failures inside the ABS control module (2001-2005)
  2. Wheel speed sensor failure mimicking a module fault
  3. Corroded module connector or ground
  4. Low system voltage upsetting the module

How to fix it — step by step

  1. Scan the ABS system and confirm the fault follows the module rather than one wheel sensor
  2. Check wheel speed sensor signals and the module connector/grounds first → Shop the wheel speed sensor at Amazon
  3. Have the module rebuilt by a specialist (solder joint repair) or replaced, then coded if required
  4. Test that ABS and traction control lights clear and stay off through a drive cycle
  5. Do not ignore it: a failed module means no ABS or traction control → Shop the abs control module at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Volvo Sedan S60 problems

See all Volvo S60 codes & guides →