Trane Furnace E08 Error Code

What the E08 code means

On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E08 means flame current is low but still strong enough to allow operation — the furnace may run, but the weak flame signal will eventually cause shutdowns.

Likely causes

  1. Dirty or oxidized flame sensor
  2. Poor burner ground
  3. Weak flame from dirty burners

How to fix it — step by step

  1. Replace the air filter and confirm registers are open
  2. Note whether the furnace short-cycles or drops out mid-cycle
  3. Book a technician visit soon — the furnace is warning before it fails
  4. A technician will clean or replace the flame sensor and verify flame current

Parts that commonly fix the E08 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Trane furnace error codes

See all Trane furnace codes & guides →