Speed Queen Washer FF Front-Load and TR Top-Load Er PS
What this problem usually means
Pressure sensor error on Speed Queen washers: the control cannot detect a valid water level sensor input, so it cannot read the fill level. Speed Queen's guide directs you to unplug the machine and call for service.
Likely causes
- Sensor harness not connected or damaged
- Failed pressure (water level) sensor
- Failed user control
How to fix it — step by step
- Unplug the washer and note the code
- Do not keep running cycles, as the washer cannot judge water level safely
- Call a technician to check the sensor harness connections
- Replace the pressure sensor or control if the error persists → Shop the pressure sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the pressure sensor.
Parts that commonly fix it
- pressure sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Speed Queen manual is on Speed Queen's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Speed Queen Washer FF Front-Load and TR Top-Load problems
See all Speed Queen FF Front-Load and TR Top-Load codes & guides →