Speed Queen Washer FF Front-Load and TR Top-Load Er dr
What this problem usually means
Drain error on Speed Queen front-load washers: water is still in the washer at the end of the cycle, per Speed Queen's front-load user guide (FLW1548C). The control also enters error mode if water is not below empty after about 2 minutes of draining on electronic models.
Likely causes
- Blocked drain hose or standpipe
- Clogged foreign-object trap in the pump
- Kinked drain hose
- Failed drain pump
How to fix it — step by step
- Check the drain hose and the standpipe or floor drain for blockages
- Clean the pump foreign-object trap as your manual shows → Shop the drain pump at RepairClinic
- Straighten any kink in the drain hose
- Unplug the washer briefly to clear the code and restart; call for service if Er dr returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix it
- drain pump - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Speed Queen manual is on Speed Queen's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Speed Queen Washer FF Front-Load and TR Top-Load problems
See all Speed Queen FF Front-Load and TR Top-Load codes & guides →