Speed Queen Washer FF Front-Load and TR Top-Load Er OF

What this problem usually means

Overflow error on Speed Queen washers: the washer has filled to the overflow level and will try to pump water out for safety.

Likely causes

  1. Water inlet valve stuck open → Shop the water inlet valve at RepairClinic
  2. Pressure sensor or its hose faulty → Shop the pressure sensor at RepairClinic
  3. Control fault reading the level wrong

How to fix it — step by step

  1. Turn off the water faucets if the washer keeps filling
  2. Unplug the washer and let it pump out or drain
  3. Restart a cycle and watch that filling stops at the normal level
  4. Call for service if it overfills again

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Speed Queen manual is on Speed Queen's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related Speed Queen Washer FF Front-Load and TR Top-Load problems

See all Speed Queen FF Front-Load and TR Top-Load codes & guides →