Speed Queen Washer FF Front-Load and TR Top-Load Er FL
What this problem usually means
Fill error on Speed Queen front-load washers: the washer has not reached the fill level within 30 minutes of a fill step.
Likely causes
- Water faucets closed or partly open
- Kinked or twisted fill hoses
- Clogged screens in the mixing valve or at the faucet end of the hoses
- Low water pressure or a pressure sensor hose air leak
How to fix it — step by step
- Turn both faucets fully on
- Straighten the fill hoses
- Clean the inlet screens in the mixing valve and at the hose ends
- Unplug the washer for 15 seconds to clear the code and restart; call for service if it returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix it
- water inlet valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Speed Queen manual is on Speed Queen's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Speed Queen Washer FF Front-Load and TR Top-Load problems
See all Speed Queen FF Front-Load and TR Top-Load codes & guides →