Samsung Washer 4E2 Error Code
What the 4E2 code means
The water from the cold supply is extremely hot, usually because the hot and cold hoses are swapped. This is an older form of the newer 4C2 hot/cold error.
Likely causes
- Hot and cold supply hoses swapped at the inlets
- Cold inlet connected to a hot supply
- Incoming water too hot for the selected delicate or wool cycle
How to fix it — step by step
- Turn off both supply taps
- Reconnect the hoses so cold (usually blue) goes to the cold inlet and hot (usually red) to the hot inlet
- Run a rinse cycle to confirm the code clears
- If the hoses were already correct, check that the cold tap is not supplying hot water
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the 4E2 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.