Samsung Washer Banging during spin
What this problem usually means
Banging during spin is an unbalanced drum striking or swinging against the cabinet as it ramps up to speed — the same condition Samsung displays as Ub, UE, U6 or Ur. Samsung's own guidance groups the causes in order: the load itself (small loads clump to one side, large items tangle), the machine's footing, leftover shipping bolts on a new install, and — when banging returns on balanced loads — worn suspension. After an install or a move, Samsung also recommends running Calibration Mode so the washer relearns the weight of an empty, level drum.
Likely causes
- Laundry tangled or bunched to one side of the drum
- A small load (a pair of jeans or two) collecting on one side, or a large load of tangled blankets and sheets
- Washer not level or rocking on its feet, or sitting on an unstable floor
- Shipping bolts left in on a new or recently moved install
- Worn suspension rods (top load) or shock absorbers (front load) that no longer damp the drum's swing
- Weight detection out of calibration after installation or a move
How to fix it — step by step
- Pause the cycle and redistribute the laundry evenly around the drum; add items to a very small load, untangle large items (wash one blanket at a time), or reduce the spin speed, then restart
- Rock the washer at all four corners: adjust the leveling legs until every foot is firm on the floor (shorten the other legs first if one corner wobbles), then tighten the locking nuts on front-load models
- On a new or just-moved washer, confirm the shipping bolts have been removed, and make sure the washer is not touching a wall or another appliance
- Run Calibration Mode with the drum empty: press and hold Temp. and Delay End together for 3 seconds until Cb shows, then press Start/Pause — the tub rotates back and forth for 1–3 minutes and ends on En, End or 0 (button combination varies by model; if your manual lists no Calibration Mode, your model does not have it)
- Test the suspension with the washer unplugged and the drum empty: push the drum down firmly — it should resist and settle after one or two gentle bounces; repeated free bouncing means worn suspension rods or shock absorbers, replaced as a full set → Shop the suspension rods at RepairClinic → Shop the shock absorbers at RepairClinic
- If banging continues after all of the above, request service — a failing drum bearing or spider arm is beyond a DIY fix
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the suspension rods.
Shop the suspension rods at RepairClinic or Amazon
Also tied to this fault: shock absorbers - Shop at RepairClinic or Amazon; leveling feet - Shop at RepairClinic or Amazon
Parts that commonly fix it
- suspension rods - Shop at RepairClinic or Amazon
- shock absorbers - Shop at RepairClinic or Amazon
- leveling feet - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.