Samsung Oven Older Models (E-Codes) E-0A Error Code
What the E-0A code means
Oven overheating / oven heating over error on older Samsung ranges.
Likely causes
- Oven temperature sensor off by more than 200 ohms → Shop the oven temperature sensor at RepairClinic
- Stuck relay / damaged electronic control board, including burns or melted wires
- Blocked vent contributing to overheating
How to fix it — step by step
- Turn the oven off and let it cool fully; check the vent is clear
- Do not restart a cycle that overheats again; switch off at the breaker
- Call for service to test the sensor and inspect the control board
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the oven temperature sensor.
Shop the oven temperature sensor at RepairClinic or Amazon
Also tied to this fault: oven electronic control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E-0A code
- oven temperature sensor - Shop at RepairClinic or Amazon
- oven electronic control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.