Toilet won't flush

If pressing the handle produces a weak flush or nothing at all, the problem is almost always inside the tank, not in the bowl: the handle lifts a chain, the chain lifts the flapper, and the tank has to be holding enough water to begin with. Work down that chain of parts in order. If the bowl fills up and rises instead of emptying, the bowl itself is clogged — that needs a plunger, not tank parts.

First checks — these apply to every brand

  1. Check the lift chain — Take the tank lid off and press the handle while you watch the chain. If it has slipped off the lever arm or the flapper, hook it back on; if it is so slack that the flapper barely rises, the flush dies before it starts. Leave only a little slack with the flapper closed — Korky specifies 1 to 2 links of slack, and Fluidmaster roughly 1/2 inch, hanging in a small J shape.
  2. Check the flapper lifts and stays up — A flapper that drops straight back onto its seat ends the flush early, which is why you end up holding the handle down. Lift the flapper by hand and let it fall: if it feels stiff, warped or waterlogged, or a hand lift gives a strong flush, replace it — flappers typically last about 3 to 5 years. Match the size when you buy: most toilets use a 2-inch flapper, some a 3-inch, and the wrong size flushes incompletely.
  3. Inspect the handle and lever arm — If the handle wobbles, tighten the nut and washer on the inside of the tank with pliers — snug, not forced, since overtightening can crack the porcelain. A handle stuck in the down position usually needs loosening and repositioning so it sits parallel with the top edge of the tank. If the arm inside is cracked or broken, replace the whole handle and arm assembly, and note your mount type (front or side) before you buy.
  4. Check the fill valve is refilling the tank — A flush can only use the water the fill valve puts back. Confirm the shutoff valve behind the toilet is fully open, and check the small refill tube is clipped to the top of the overflow pipe — if it has come off, the bowl underfills and the flush is weak. Sediment can also choke the valve: many fill valves can be opened at the cap and flushed clean, or have a strainer you can rinse, and a valve that still will not refill should be replaced.
  5. Set the tank water level — Too little water in the tank means a weak flush no matter how well the parts move. After a refill, the water should stop roughly 1/2 inch below the top of the overflow pipe. On most modern fill valves, turn the adjustment screw clockwise to raise the float and the level, counterclockwise to lower it, then flush once to reset the level and check again.

Which is yours?

Pressing the handle does nothing - The linkage is broken somewhere: the chain has come off the lever arm or the flapper, the chain has snapped, or the handle arm itself has broken. Start with the chain check, then the handle check — lifting the flapper by hand should still flush the toilet while you get the part.

It flushes, but weakly — or I have to hold the handle down - The flapper is closing too early or the tank is not holding enough water. Work the flapper, fill valve and water level checks: a worn flapper, a float set too low, or a refill tube that has slipped off the overflow pipe are the usual causes.

More plumbing problems: Toilet keeps running · Sink won't drain · Tub or shower drain is slow · Garbage disposal won't run

Parts that commonly fix it

When to call a pro: Call a plumber if the bowl backs up and a plunger or closet auger will not clear it, if water leaks from the tank base or the supply connection, or if a new flapper, handle and fill valve still do not produce a flush — at that point the flush valve or the drain line itself is the problem.