Sink won't drain
Most sink clogs sit close to the fixture — at the stopper, in the trap, or just inside the wall — so work from the least invasive tool to the most: plunger, then snake, then a cleaner, then the trap itself. If more than one drain in the house is backing up, skip this ladder: that is a main-line problem.
First checks — these apply to every brand
- Plunge it first — Pull out the stopper, then block the sink's overflow hole with a wet cloth (and plug the other bowl of a double sink with a wet rag) so the plunger's pressure reaches the clog instead of escaping. Fill the sink with a few inches of water to cover the cup of a flat-bottom sink plunger, make the first plunge a gentle one to push the air out, then plunge vigorously with a push-and-pull motion, 15 to 20 times.
- Run a drain snake — Feed a hand auger (drain snake) into the drain opening, turning the handle as you push so the cable works around the bends. When you feel resistance you have reached the clog: keep cranking clockwise so the head bites in or hooks it, pull back slightly, then withdraw the cable and wipe it clean as it comes out. Run water to confirm the drain is clear.
- Use an enzyme or chemical cleaner — exactly as the label says — For the sludge and hair coating the pipe, an enzyme cleaner digests the organic buildup and is safer for pipes and septic systems than a caustic cleaner; give it hours or overnight to work, then flush with hot water. If you use a caustic gel such as Drano instead, SC Johnson's directions are to pour it slowly into the drain, wait 15 minutes (30 for tough clogs), then flush with hot — not boiling — water. Never use a plunger during or after using it, never mix it with any other cleaner or chemical, and never use it in a toilet.
- Take the P-trap apart and clean it — Put a bucket under the trap, loosen the two large compression nuts on the curved section with slip-joint pliers, and drop the trap out. Scrape out the grease and debris inside, and check the tailpiece above it and, on a kitchen sink, the elbow at the garbage disposal and the baffled T-fitting just past it — that fitting narrows the pipe and is a common choke point. Reassemble, fill the sink, pull the plug and watch underneath for drips.
Which is yours?
Sink with a garbage disposal - The disposal side usually backs up first, because food waste collects at the disposal outlet and the baffled T-fitting just beyond it. Run cold water and switch the disposal on for a few seconds to confirm it turns over — if it hums or does nothing, fix that first. Never reach into the drain to clear it; use tongs. Drano's label does cover disposal drains, but if the drain has not cleared, do not switch the disposal on, because the cleaner can splash back.
Sink without a garbage disposal - Work the ladder in order. In a bathroom sink the clog is usually hair and soap scum wrapped around the stopper — pull the stopper and clean it by hand before reaching for tools. In a kitchen sink without a disposal, expect grease and food in the trap, which is why the trap clean-out is the decisive step.
More plumbing problems: Toilet won't flush · Toilet keeps running · Tub or shower drain is slow · Garbage disposal won't run
Parts that commonly fix it
- drain snake — Shop at Amazon
- plunger — Shop at Amazon
- enzyme drain cleaner — Shop at Amazon
When to call a pro: Call a plumber if both bowls of a double sink, or several drains around the house, back up together, if you smell sewage, or if water rises in a lower fixture when another one drains — that is a blockage in the main line, which needs a power auger or a camera, not a sink snake. Also call if the clog is still there after the trap is clean and a full snake run.