Narwal Robot vacuum Narwal Freo Z Base station not producing hot wash water
What this problem usually means
The base station wash water is not heating for mop washing. Narwal's base-station troubleshooting guide explicitly lists the Freo Z Ultra among the models with hot-water mopping functionality.
Likely causes
- Base station fault / needs restart
How to fix it — step by step
- Unplug the base station power cord to restart the base station.
- If the issue persists, contact Narwal support.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.