Narwal Robot vacuum Narwal Freo Z 2040 / 2041 / 2042 Error Code
What the 2040 / 2041 / 2042 code means
Electrolyzed water module malfunction in the base station. The Freo Z Ultra base station has a built-in electrolyzed-water module for mop washing (confirmed on its official Product Help page); these codes are the electrolyzed-water module codes in Narwal's robot-vacuum error index.
Likely causes
- Electrolyzed water module fault in the base station
How to fix it — step by step
- Power-cycle the base station by disconnecting its power supply, then restart it.
- If the issue persists, contact Narwal support.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the 2040 / 2041 / 2042 code
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.