Mercedes-Benz Sedan E-Class Oil leak from camshaft adjuster magnet
What this problem usually means
The E-Class's four-cylinder (E 300, M274; E 350, M264) and V6 (M276) engines use camshaft adjuster magnets whose internal seals harden with heat, letting engine oil seep into the electrical connector and wick along the wiring harness toward other connectors and, in the worst cases, the engine control unit. The magnets are replaced, the oily connector dealt with, and the harness checked.
Likely causes
- Camshaft adjuster magnet seal hardened with heat → Shop the camshaft adjuster magnet at Amazon
- Oil wicking through the harness toward the ECU
How to fix it — step by step
- Inspect the camshaft magnet connectors at the front of the engine for oil
- Scan for camshaft/timing fault codes
- Replace the leaking magnet(s) and clean the connector
- Check the harness and ECU connector for oil travel
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the camshaft adjuster magnet.
Parts that commonly fix it
- camshaft adjuster magnet - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.