LG Washer tE Error Code

What the tE code means

Temperature sensor (thermistor) error: the washer detects a fault with the water temperature sensing / heating control.

Likely causes

  1. Failed thermistor (temperature sensor) → Shop the thermistor at RepairClinic
  2. Loose or damaged sensor wiring
  3. Heating element or control board fault → Shop the heating element at RepairClinic

How to fix it — step by step

  1. Turn the washer off and unplug it for a few minutes, then restart
  2. Run a cold-water cycle to see if the code returns
  3. If tE returns, stop and book service - the sensor is internal

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the tE code

Before you buy: check the thermistor first

Test: Disconnect the wash thermistor and measure its resistance at room temperature.

A good one reads: 50–60 kΩ at room temperature (LG WM9000H*A service manual ohms test).

Test values from manualslib.com documentation - confirm against your model's own tech sheet.

Before you buy: check the heating element first

Test: Disconnect the wash heater and measure resistance across its terminals.

A good one reads: 14.4 Ω (LG WM9000H*A service manual: wash heater rated 1000 W at 120 VAC). Open (OL) means the heater has failed.

Test values from manualslib.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related LG Washer error codes

See all LG washer codes & guides →