LG Washer Banging during spin
What this problem usually means
Banging or thumping during spin is the tub swinging off balance at high speed — LG washers spin past 1,300 RPM, so even a slight imbalance becomes a loud racket, and the washer repeatedly stops and rebalances the load (this is the same condition that surfaces as a UE error). Brief banging while the washer rebalances is the machine protecting itself; banging on most loads, or on an empty drum, means the cause is no longer the laundry — leveling, leftover shipping bolts, or worn suspension parts.
Likely causes
- Laundry bunched or unevenly distributed on one side of the drum
- Loads that cannot balance: a single heavy item, or items LG says not to machine-wash such as door mats, rugs and rubber mats
- Washer not level — one or more feet not in firm contact with the floor
- Shipping (fixing) bolts never removed on a new or recently moved front-load install — the locked tub cannot float on its suspension
- Worn shock absorbers/dampers, and on older machines worn tub bearings or a damaged spider arm (LG's causes for persistent loud banging)
How to fix it — step by step
- Press Start/Pause, open the door and redistribute the laundry evenly around the drum; add an item or two to a very small load, and wash bulky items one at a time on the Bedding cycle
- Remove anything that cannot balance (mats, rugs, rubber-backed items) and restart a Rinse + Spin cycle
- Rock the washer corner to corner: if it moves, use the supplied spanner to adjust the leveling feet until every leg is firm on the floor → Shop the leveling feet at RepairClinic
- On a new or just-moved washer, check the shipping bolts: open the door and push the tub front to back — if it will not move, the bolts are still in; remove all of them from the rear with a spanner and cap the holes (keep the bolts for any future move)
- If it still bangs on balanced loads or empty, the suspension is worn — inspect or replace the shock absorbers/dampers as a set; persistent banging with grinding or rumbling points to tub bearings or the spider arm, which is a service job → Shop the shock absorbers / dampers at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the shock absorbers / dampers.
Shop the shock absorbers / dampers at RepairClinic or Amazon
Also tied to this fault: leveling feet - Shop at RepairClinic or Amazon
Parts that commonly fix it
- shock absorbers / dampers - Shop at RepairClinic or Amazon
- leveling feet - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.