LG Robot vacuum HOM-BOT Square HOM-BOT will not charge due to a problem with the cliff sensors.

What this problem usually means

Smart Diagnosis result: charging is blocked by a cliff-sensor problem.

Likely causes

  1. Cliff sensors dirty or faulty

How to fix it — step by step

  1. Clean the three Cliff Sensors on the bottom at the front of the unit
  2. Run Smart Diagnosis again; if the same message is announced, contact an LG Electronics service center

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related LG Robot vacuum HOM-BOT Square problems

See all LG HOM-BOT Square codes & guides →