LG Robot vacuum HOM-BOT Square HOM-BOT will not charge due to infrared sensor error.
What this problem usually means
Smart Diagnosis result: charging is blocked by an infrared sensor error.
Likely causes
- Infrared sensor error
How to fix it — step by step
- Turn the main power switch on the back of the HOM-BOT 'Off', then 'On' again
- Run Smart Diagnosis again
- If the same message is announced, contact an LG Electronics service center
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related LG Robot vacuum HOM-BOT Square problems
- HOM-BOT will not charge due to ultrasonic sensor error.
- Please check for foreign material on the left wheel.
- Please check for foreign material on the right wheel.
- Please check if the charging terminal is damaged or dirty.
- Please check that the dust bin and filter are properly installed.
- Please clean the camera sensor on bottom right side.
- Please clean the obstacle detecting sensor windows on the left and right side of the HOM-BOT.
- Please remove any foreign material on the left/right wheel.
- Smart diagnosis has failed to complete its diagnostics.
- The wheels are not touching the floor. Please move HOM-BOT onto flat floor.
- Unable to initiate smart diagnosis due to a low battery.
- A problem has been found in the acceleration sensor.