Lexus SUV NX (AZ10, 2015–2021) Water pump failure and coolant leak
What this problem usually means
On the first-generation NX 200t's 2.0L turbo (8AR-FTS), water pump failures can appear as early as 20,000 miles on early production units, per What-Breaks' NX AZ10 guide. Replacement often requires timing chain kit removal due to the pump's location, and overheating from pump failure can cause irreparable damage to the aluminum block.
Likely causes
- Premature water pump bearing/seal failure, as early as 20,000 miles on early units
- Coolant leaking from the pump onto the timing chain area
How to fix it — step by step
- Watch for coolant leak, overheating, low coolant warning, or antifreeze pooling under the engine
- Stop driving and let the engine cool if the temperature rises; overheating can destroy the aluminum block
- Have the cooling system pressure-tested to confirm the pump as the leak source
- Replace the water pump; if coolant has leaked onto the timing chain, the chain kit may need replacement at the same time → Shop the timing chain kit at Amazon → Shop the water pump at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the water pump.
Also tied to this fault: timing chain kit - Shop at Amazon
Parts that commonly fix it
- water pump - Shop at Amazon
- timing chain kit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.