Kia SUV Telluride Engine knocking noise
What this problem usually means
The Telluride's knock-sensor monitoring system detects vibration patterns from early connecting rod bearing wear and triggers code P1326 with a reduced-power limp mode. Symptoms are a continuously blinking check engine light, noticeable power loss with rpm limited to roughly 1,800-2,000, and often an audible knock alongside elevated oil consumption; once bearing wear is confirmed, a full engine replacement is usually required.
Likely causes
- connecting rod bearing wear detected by the knock sensor system
How to fix it — step by step
- Stop driving if the check engine light is blinking and power is limited - the car is in limp mode
- Check the oil level and do not top up and keep driving on a knocking engine
- Scan for code P1326 and record it before clearing anything
- Have a dealer or shop confirm bearing wear under the knock-sensor program; confirmed wear usually means engine replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the connecting rod bearings.
Parts that commonly fix it
- connecting rod bearings - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.