Kia SUV Telluride Carbon buildup on intake valves
What this problem usually means
The Telluride's 3.8L Lambda II V6 uses gasoline direct injection, so fuel never washes the intake valves and carbon deposits build up there over time. The documented fix is a walnut blast cleaning at around 80,000 miles, and periodic cleaning helps prevent the rough idle and misfires the deposits cause.
Likely causes
- carbon deposits on the intake valves of the direct-injection v6
How to fix it — step by step
- Note rough idle or misfires and scan for misfire codes to rule out coils and plugs first
- Ask about intake valve cleaning history on a car near or past 80,000 miles
- Keep to the manufacturer's oil schedule with the specified grade, which matters more than usual on this engine
- Have a specialist walnut-blast the intake valves to remove the deposits
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the spark plugs.
Parts that commonly fix it
- spark plugs - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.