Goodman Furnace 1 flash
What this problem usually means
System lockout because ignition retries were exceeded on Goodman GMES96-series furnaces with the red LED diagnostic board. The furnace tried to light, failed to prove flame, and shut down for safety.
Likely causes
- failed ignition attempts
- no gas supply to the burners
- faulty hot surface igniter
- dirty or failed flame sensor
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic
- flame sensor - Shop at RepairClinic
- gas valve - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.