Goodman Furnace 11 flashes
What this problem usually means
Igniter open on Goodman GMES96-series furnaces. The control sees an open igniter circuit, so the igniter cannot heat up to light the burners.
Likely causes
- cracked or burned-out hot surface igniter
- disconnected or loose igniter wire
- failed igniter circuit on the control board
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic
- control board - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.