Frigidaire Washer Top-Load E2 Error Code
What the E2 code means
On a top-load washer, water is taking too long to drain from the tub.
Likely causes
- Drain hose kinked or clogged
- Standpipe too low or blocked
- Lid not fully closed
- Drain pump obstructed
How to fix it — step by step
- Check the drain hose for kinks and clogs
- Make sure the standpipe height matches the manual
- Close the lid firmly and restart the cycle
- If it still drains slowly, have the drain pump checked → Shop the drain pump at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix the E2 code
- drain pump - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.