Frigidaire Washer Top-Load E1 Error Code
What the E1 code means
Long fill time on a top-load washer: the tub is not filling with water as fast as it should.
Likely causes
- Water supply faucets not fully open
- Fill hoses kinked or clogged
- Clogged inlet valve screens → Shop the water inlet valve at RepairClinic
- Low household water pressure
How to fix it — step by step
- Make sure both hot and cold faucets are fully open
- Straighten the fill hoses and check for kinks
- Turn off the water, disconnect the hoses and clean the inlet screens
- Restart the cycle and see if the code returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix the E1 code
- water inlet valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Frigidaire manual is on Frigidaire's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.