Dreame Robot vacuum Dreame X40 Ultra The robot misses the rooms to be cleaned
What this problem usually means
Rooms that should be cleaned are skipped.
Likely causes
- Doors of the rooms to be cleaned are closed
- A threshold higher than about 2 cm at the door (the robot cannot climb over high thresholds or steps)
- The place in front of the room is wet and slippery, causing the robot to slip and work abnormally
How to fix it — step by step
- Make sure the doors of the rooms to be cleaned are open
- Check for a threshold higher than about 2 cm at the door of the room
- Dry the floor in front of the room before using the robot
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame X40 Ultra problems
- The robot moves without following the set route
- The robot will not charge
- The robot will not resume cleaning after charging
- The robot will not turn off
- The robot will not turn on
- The station cannot automatically empty the dust box
- The water level in the washboard is abnormal
- Voice prompt: "Laser sensor abnormal / LDS abnormal"
- Docking failed (robot repeatedly docks or fails to dock for charging)
- Robot fails to collect dust at the base station
- Side brush does not rotate / "Side brush entangled, please clean"
- The charging speed is slow