Dreame Robot vacuum Dreame X40 Ultra Voice prompt: "Laser sensor abnormal / LDS abnormal"
What this problem usually means
The robot announces a laser sensor (LDS) abnormality, or the retractable LDS cannot be raised or lowered (article written for the X40 Ultra Complete).
Likely causes
- The LDS component is stuck by foreign objects and cannot rotate
- The laser emission and reception holes of the LDS are blocked by foreign objects
- The LDS cannot be raised or lowered
How to fix it — step by step
- Confirm whether the LDS component is stuck by foreign objects and cannot rotate; gently move the LDS to try
- Confirm whether the front, back, left, and right sides of the LDS cover can be gently moved
- Check whether the laser emission and reception holes of the LDS are blocked by foreign objects and clear them
- If the LDS cannot be raised or lowered, reset and restart the machine and observe whether the LDS rises or falls (note: resetting clears all data, including maps)
- If none of these steps resolve the issue, contact Dreame support
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame X40 Ultra problems
- Docking failed (robot repeatedly docks or fails to dock for charging)
- Robot fails to collect dust at the base station
- Side brush does not rotate / "Side brush entangled, please clean"
- The charging speed is slow
- The mop pad holder is raised abnormally
- The noise increases while the robot is operating
- The robot cannot find and return to the base station
- The robot fails to connect to Wi-Fi
- The robot gets stuck in front of the base station and cannot return to it
- The robot misses the rooms to be cleaned
- The robot moves without following the set route
- The robot will not charge