Coway Air purifier AP-1512HH Pollution level indicator always stays the same
What this problem usually means
The color of the pollution level indicator always stays the same, per the AP-1512HH troubleshooting table.
Likely causes
- Dust on the pollution (air quality) sensor's lens
- Sensor sensitivity set wrong for actual conditions - level keeps indicating high, or keeps indicating low
How to fix it — step by step
- Clean the lens of the pollution sensor (see the sensor-cleaning entry for this model)
- If the level keeps indicating high, adjust the sensitivity of the pollution sensor to Insensitive or Standard; if it keeps indicating low, adjust it to Sensitive or Standard
- To adjust sensitivity: while the purifier is on, press the airflow speed button and ionizer button for 2 seconds, press the speed button to select Sensitive (speed step 1), Standard (step 2) or Insensitive (step 3), then press the speed and ionizer buttons for 2 seconds again - the new setting also applies if no button is pressed for 10 seconds
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.