Bosch Washer E31 Error Code
What the E31 code means
The maximum water level in the drum has been exceeded — the washer has overfilled or believes it has. It is also shown as F31 or E00-31.
Likely causes
- Water inlet valve stuck open or not closing → Shop the water inlet valve at RepairClinic
- Faulty pressure sensor misreading the level → Shop the pressure sensor at RepairClinic
- Drain pump or drain hose problem preventing water leaving
- Incorrect drain hose installation causing siphoning problems
How to fix it — step by step
- Turn off the water tap and unplug the washer
- Select a drain programme once power is restored to empty the drum, or drain via the pump filter into a shallow pan
- Clean the pump filter and check the drain hose for kinks or blockages
- If the washer overfills again, keep the tap off and book a technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Shop the water inlet valve at RepairClinic or Amazon
Also tied to this fault: pressure sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the E31 code
- water inlet valve - Shop at RepairClinic or Amazon
- pressure sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Bosch manual is on Bosch's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.