Bosch Washer E:36 -10 Error Code

What the E:36 -10 code means

The detergent solution is not being pumped out — on current five-digit-display models this is the drain fault also shown as E:18 on other models.

Likely causes

  1. Drain pump blocked
  2. Drain pipe or outlet hose blocked
  3. Outlet hose kinked, trapped, connected too high (over 1 metre) or extended with an unapproved extension
  4. Pump cover not correctly assembled or pump cap not fully screwed in
  5. Detergent dosage too high causing oversudsing

How to fix it — step by step

  1. Switch off and unplug the washer
  2. Check the outlet hose installation: no kinks, no unapproved extensions, and no higher than 1 metre
  3. Clean the drain pipe and outlet hose
  4. Open the service flap, drain the water into a shallow pan, clean the drain pump and make sure the pump cap is screwed fully in with its handle vertical
  5. Reduce the detergent dose if there was heavy foaming, then run a drain programme to test

Parts that commonly fix the E:36 -10 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Bosch washer error codes

See all Bosch washer codes & guides →