Whirlpool Washer Front-Load and Top-Load HE Lo FL
What this problem usually means
Low flow: the washer is sensing a low flow of water during fill, the same fault shown as F8 E1 on other models.
Likely causes
- Faucets not fully open
- Kinked inlet hoses
- Clogged inlet screens
- Anti-flood hose/device restricting flow
How to fix it — step by step
- Open both hot and cold faucets fully
- Straighten inlet hoses and clean inlet screens
- Remove anti-flood devices from the water line
- Press Pause/Cancel twice and Power once to clear (front-load)
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix it
- water inlet valve - Shop at RepairClinic or Amazon
Before you buy: check the water inlet valve first
Test: Unplug the washer and measure each fill valve solenoid's coil resistance at the valve or at the ACU connector pins listed in the tech sheet.
A good one reads: 1100–1350 Ω per coil (Whirlpool tech sheet W11417646, Test #6). Older Duet solenoids spec 800 Ω — use the range on your model's tech sheet; open or far out of range means replace the valve assembly.
Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Whirlpool Washer Front-Load and Top-Load HE problems
See all Whirlpool Front-Load and Top-Load HE codes & guides →