Whirlpool Washer Front-Load and Top-Load HE F8 E1 Error Code

What the F8 E1 code means

Long fill / low water flow: the washer is taking too long to fill or is sensing too little incoming water. Also shown as LF or Lo FL on some models.

Likely causes

  1. Hot or cold faucet not fully open or turned off
  2. Kinked inlet hoses
  3. Clogged inlet valve screens → Shop the water inlet valve at RepairClinic
  4. Low household water pressure
  5. Failed water inlet valve

How to fix it — step by step

  1. Turn on the water and open both hot and cold faucets completely - both must be supplied
  2. Check inlet hoses are not kinked and remove any anti-flood/flood-safe devices in the line
  3. Turn off water, disconnect hoses and clean the inlet screens
  4. Press Pause/Cancel twice and Power once to clear, then restart

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F8 E1 code

Before you buy: check the water inlet valve first

Test: Unplug the washer and measure each fill valve solenoid's coil resistance at the valve or at the ACU connector pins listed in the tech sheet.

A good one reads: 1100–1350 Ω per coil (Whirlpool tech sheet W11417646, Test #6). Older Duet solenoids spec 800 Ω — use the range on your model's tech sheet; open or far out of range means replace the valve assembly.

Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related Whirlpool Washer Front-Load and Top-Load HE error codes

See all Whirlpool Front-Load and Top-Load HE codes & guides →