Toyota Wagon Sienna Check engine light from EVAP system failure
What this problem usually means
A few Sienna owners have reported problems with the evaporative emission (EVAP) system, with the check engine light coming on when there is a problem. It usually happened because a canister needed to be replaced - around $300 - while other owners had problems due to a loose gas cap and had to replace the cap.
Likely causes
- failed evap charcoal canister
- loose or failed gas cap
How to fix it — step by step
- Tighten the gas cap and drive a few cycles - a loose cap is the cheapest EVAP fault there is → Shop the gas cap at Amazon
- Have the codes read and write down the exact EVAP code
- Replace the gas cap if its seal is cracked or it no longer clicks and holds
- Have the charcoal canister tested and replaced if it is confirmed faulty → Shop the charcoal canister at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the charcoal canister.
Shop the charcoal canister at Amazon
Also tied to this fault: gas cap - Shop at Amazon
Parts that commonly fix it
- charcoal canister - Shop at Amazon
- gas cap - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Toyota manual is on Toyota's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.