Toyota SUV 4Runner Won't start due to corroded starter contacts

What this problem usually means

On third- and fourth-generation 4Runners the starter solenoid contacts can corrode, so turning the key produces a ticking sound and the engine refuses to crank, or the SUV stops suddenly. Many owners fixed it by replacing the starter or its solenoid contacts.

Likely causes

  1. corroded starter solenoid contacts
  2. failed starter motor

How to fix it — step by step

  1. Listen for a single click or repeated ticking when you turn the key, with the dash lights staying bright
  2. Rule out a weak battery and clean, tight battery terminals first
  3. Have the starter circuit tested to confirm power is reaching the starter
  4. Replace the solenoid contacts or the starter motor if the starter does not turn with power applied → Shop the starter solenoid contacts at Amazon → Shop the starter motor at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Toyota manual is on Toyota's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Toyota SUV 4Runner problems

See all Toyota 4Runner codes & guides →